Hello,
Long time lurker here, so thanks for all your advice in the past.
I'm due to install a ring floodlight on the rear of my property, which currently has no external power.
I plan on chasing an FCU in to the bedroom wall, fed off the upstairs ring final. This I plan on sticking a 5A fuse in to. I then plan on surface mounting rubber flex along the wall to the ring floodlight.
The problem is the floodlight only allows rear entry, the instructions mention using a 4inch round junction box to facilitate the cable run, then screwing the floodlight directly to this. However, I can't find anything suitable in width or IP rating.
Has anyone fitted one?
Any suggestions please?
Cheers
Long time lurker here, so thanks for all your advice in the past.
I'm due to install a ring floodlight on the rear of my property, which currently has no external power.
I plan on chasing an FCU in to the bedroom wall, fed off the upstairs ring final. This I plan on sticking a 5A fuse in to. I then plan on surface mounting rubber flex along the wall to the ring floodlight.
The problem is the floodlight only allows rear entry, the instructions mention using a 4inch round junction box to facilitate the cable run, then screwing the floodlight directly to this. However, I can't find anything suitable in width or IP rating.
Has anyone fitted one?
Any suggestions please?
Cheers