Lighting help (wiring)

[gazdkw82]

I've got the following set up

Ex-or lightspot HD PIR dali
2x Jc71361 Dali

I'm a little baffled by the wiring.

The instructions that come with the pir are as follows



The bit I'm struggling with is, what is "switching luminaries"?

It's coming from the switch load but I'm not sure what that is.

The jcc fittings have a ballast which has mains and Dali control. In the diagram, mains supply is taken to the ballast. Where is the switch load going?

 

[JAWS]

Not sure if this will help.
http://ecsaustralia.net.au/wp-content/uploads/2014/11/LS-Quicklink-BUS.pdf

 

[gazdkw82]

Not sure if this will help.
http://ecsaustralia.net.au/wp-content/uploads/2014/11/LS-Quicklink-BUS.pdf

That's what I have already

 

[buzzlightyear]

it means switching from one area to another .white croft install read what it says on constructions .

 

[gazdkw82]

it means switching from one area to another .white croft install read what it says on constructions .

So where does the switch load actually go?

 

[Lucien Nunes]

'Luminaries' = wise people
'Luminaires' = light fittings
When will predictive text apps learn this?

AFAIK it simply means that the switched output is available for any fittings that aren't digitally controllable. If all your fittings are on DALI, you don't need it.

 

[davesparks]

So where does the switch load actually go?

It goes to any non-dali loads that need to be switched by this PIR

 

[gazdkw82]

It goes to any non-dali loads that need to be switched by this PIR

Ah that makes sense now.