Hi,
have a shower connect up, the run to CU is maybe 8 metres, (3036's) but the CU is in a meter cupboard outside.
There is no space to put a rcd unit inside, and not enough room for a henley block..
was going to get a plug in 40a wylex mcb as there is an existing spare way in the CU, go through the wall (the room with a separate shower room is directly behind the existing board)
and use a small shower CU with RCD to connect this, Ideally it would have 16mm tails from a henley block but i cant do that with space constraints...
Is it pointless to go from original CU, 40a plug in wylex, into rcd unit with a 40a 60898? i am assuming the plug in wylex's have the same disconection times?
have a shower connect up, the run to CU is maybe 8 metres, (3036's) but the CU is in a meter cupboard outside.
There is no space to put a rcd unit inside, and not enough room for a henley block..
was going to get a plug in 40a wylex mcb as there is an existing spare way in the CU, go through the wall (the room with a separate shower room is directly behind the existing board)
and use a small shower CU with RCD to connect this, Ideally it would have 16mm tails from a henley block but i cant do that with space constraints...
Is it pointless to go from original CU, 40a plug in wylex, into rcd unit with a 40a 60898? i am assuming the plug in wylex's have the same disconection times?