New Phase Rotation Meter.

[Guest123]

Need a new one, anyone have a fave???

Liking the megger one at test-meter.....

Megger PSI410 Phase Sequence Indicator - Phase Rotation Meter

 

[Guest123]

Thanks for the replies folks.:hurray:


Went with a megger in the end.

 

[jumpin jax]

Megger seem to be producing good quality affordable products recently, will be my choice in the future i think when work picks up

 

[DurhamSparky]

i have a "borrowed" fluke one!!

its my fav!! lol

 

[johnboy6083]

i use my fluke 1652. works fine. also got an earth electrode tester built in.

 

[Guest123]

i use my fluke 1652. works fine. also got an earth electrode tester built in.

My 1653 does that too but, I dont like bringing it out when fault finding on machines etc, in a minging old factory where everything is covered in oil & grease etc.

Just want a small unit to keep in the toolbag.

The megger does that just right.:biggrin:

 

[johnboy6083]

Very true. I like to keep my meter clean too. My fluke T5-100 gets minging!

 

[Guest123]

Hate dirty tools me, after a filthy shift I'm usually found in the back of the van surrounded by a pile of industrial hand wipes cleaning all me tools.:rolleyes4:


Just this morning, I've been in the shed with the wire wheel in the drill cleaning up all me shifters, footprints & pipe grips etc. VERY SAD I know.:goofy:

 

[johnboy6083]

That is sad but neccesary! I can tell your properly self employed, I do mine on site in works time. I periodically give everything a dose of WD40, and like you, give everything a wipe. My bugbear is wet tools, which seems to happen every time I do plumbing/pipe fitting. Often there's no bleed valve for pressure switches or transducers, so I always fit them with water flowing. I get a little wet, but at least I have 100% confidence in the readings.