H
hatterman
Hi all,
I am currently have an amplifier that is powered by an ac/dc adapter (as shown in diagram below). In my house I have CAT5 cable run from where the amplifier is to a position on the wall (it is currently not being used). I want to be able to push a button on the wall where the CAT5 cable goes to with the result that the amplifier is either powered on or off. Would the setup in the diagram work? The adapter has two wires coming out of it (positive and neutral?), so I planned to keep the positive wire uncut and the neutral wire would be joined to the CAT5 loop with the push switch in.
Many thanks for any advice.
I am currently have an amplifier that is powered by an ac/dc adapter (as shown in diagram below). In my house I have CAT5 cable run from where the amplifier is to a position on the wall (it is currently not being used). I want to be able to push a button on the wall where the CAT5 cable goes to with the result that the amplifier is either powered on or off. Would the setup in the diagram work? The adapter has two wires coming out of it (positive and neutral?), so I planned to keep the positive wire uncut and the neutral wire would be joined to the CAT5 loop with the push switch in.
Many thanks for any advice.