Here’s one for you....

[buzzlightyear]

I'd go with a glue gun

if it can hold a curtain up it will Shirley led strip .

 

[Deuce]

What green dot? I only see a squiggly red line and a yellow dash.

I was too polite to point out the state of the sketch and the fact it's blatantly a yellow dash.

 

[buzzlightyear]

What green dot? I only see a squiggly red line and a yellow dash.

dark glasses again L/S , the vampire must still have them on wright P/P .

 

[buzzlightyear]

I was too polite to point out the state of the sketch and the fact it's blatantly a yellow dash
I know their is a red squiggly line with a hook on it where kid have drawn, and waiting for the worm.

 

[H]

Good old pink grip?

 

[buzzlightyear]

Good old pink grip

indeed marigolds. LOL.

 

[Deleted account]

Eh!

 

[Deleted member 26818]

Any glue or sticky stuff, will only be as strong as the paint the LED strip is stuck to.

 

[Idpost]

Mitre bond Mitre Adhesive Kit 50g + 200ml - https://www.toolstation.com/shop/p47409?r=googleshopping&rr=marin&utm_source=googleshopping&utm_medium=feed&utm_campaign=googleshoppingfeed&gclid=Cj0KCQiA8f_eBRDcARIsAEKwRGdG6DT7kXscwMAzW_baAR9Wt41vAh86EXmM6ltpEu2cq9kja6tnuz0aAjTEEALw_wcB

 

[GBDamo]

This? Don't know where to buy the clips, or what they're called

Just get some oversize P clips and flatten them.

 

[stevels4]

I’m not a plumber how dare you insinuate i own a gas torch it would work but I bet the circuit board would melt

I’m not a plumber either but do have a gas torch..how else could I heat shrink break out boots and sleeving?

 

[Deuce]

I’m not a plumber either but do have a gas torch..how else could I heat shrink break out boots and sleeving?

Heat gun.

 

[Pete999]

What he said^^^^^^^^^^^^^^^^^^^^^^

 

[MFS Electrical]

Lighter?

 

[Dave OCD]

Just use large T&E clips and substitute the pins for thin screws.

 

[w0z]

Self adheasive velcro?

Whenever I've used it the self-adhesive bit eventually falls off no matter how well prepared the surface is, but the velcro part is good!