I have LEDs under wall cabinets and in the bases of plinths to provide floor lighting. All looks good until you look inside or under the units. The required 12v drivers (power units - 240 to 12v) are free to float around and the very small twin flex to the LEDs themselves is difficult to fix and protect. At floor level it is not too bad because it is not normally seen or disturbed, but in the wall cabinets the wires must go to the centre of the cabinet base where the LED is located.
What is the best way to tidy it all up and protect the wires?
Comments appreciated.
What is the best way to tidy it all up and protect the wires?
Comments appreciated.