- Reaction score
- 0
My beko will not run, it attempts to move in both directions with a belt or not fitted also shows no faults in checking with a meter across its tacho, stator or field as it will not run.
The brushes are a good length of 30/40mm when removed.
Need to bench test to prove if the motor is at fault or pcb board.
Got a 8 wire connector, earth, 2 x red for tacho, 2 for stator and 2 or 3 for the field.
In between the two field wires brn and org is a blk wire. Is this the thermal wire ?
If so, can i then bridge the stator and field wires to carry out a bench test.
Thanks
The brushes are a good length of 30/40mm when removed.
Need to bench test to prove if the motor is at fault or pcb board.
Got a 8 wire connector, earth, 2 x red for tacho, 2 for stator and 2 or 3 for the field.
In between the two field wires brn and org is a blk wire. Is this the thermal wire ?
If so, can i then bridge the stator and field wires to carry out a bench test.
Thanks