Re: Clearing to concrete posts?
Hi fella,if your customer did not listen to your initial advice,why would he listen to any further ideas?...:49:
....Anywho...there are other ways to affix conduit,duct or SWA to post & panel. Probably best not to drill the posts,but i have drilled the panels,in the past,an inch up or down from the center line,a foot in from the ends. I made cable/conduit clamps up from Stauff hydraulic mounts.which have two plastic half shells for clamping,and a steel back plate,you can fix threaded rod to.
You could make up "C" clamps,for your side of the posts,and i have also used my own method,where access or tinkering the other side is restricted. If you make up clip or clamp bases with 20mm of M6 threaded rod protruding,you can drill inch deep holes,and fix with Hilti cavity tie resin. This,or similar,is very durable,and maintains the integrity of the drilled item.
I will be honest,if he had ignored advice from myself,having asked for it...i would be telling him to get busy with a wind-up extension lead,and wish him a good night :bobby: