1 or 2 junction boxes for induction stove top and wall oven?

[ian-san-diego]

We are renovating our kitchen, and part of the renovation involves replacing our gas oven with an induction stovetop built into the counter and a wall oven built into the cabinet below. I have added two breakers to the panel and run romex from each one to the kitchen area, creating one dedicated 240V circuit for the stovetop and another dedicated 240V circuit for the wall oven. The wall oven installation instructions ask that the junction box be in a pretty specific spot in the wall behind the oven. The stovetop instructions are less specific, but the junction box for this is also supposed to be below the counter. I am a novice doing DIY electrical work in my house. My question is, if a real electrician were doing this job, would they put the connections for these two units in two separate junction boxes, or would they put them in a single junction box? To be clear, in both cases the wall oven and stovetop are on separate circuits, but I am just wondering whether to put all the connections in a single junction box.
Thanks!
Ian
(I am a new member, and this is my first post on this forum, although I have read many really useful posts on this forum in the past.)

 

[Megawatt]

We are renovating our kitchen, and part of the renovation involves replacing our gas oven with an induction stovetop built into the counter and a wall oven built into the cabinet below. I have added two breakers to the panel and run romex from each one to the kitchen area, creating one dedicated 240V circuit for the stovetop and another dedicated 240V circuit for the wall oven. The wall oven installation instructions ask that the junction box be in a pretty specific spot in the wall behind the oven. The stovetop instructions are less specific, but the junction box for this is also supposed to be below the counter. I am a novice doing DIY electrical work in my house. My question is, if a real electrician were doing this job, would they put the connections for these two units in two separate junction boxes, or would they put them in a single junction box? To be clear, in both cases the wall oven and stovetop are on separate circuits, but I am just wondering whether to put all the connections in a single junction box.
Thanks!
Ian
(I am a new member, and this is my first post on this forum, although I have read many really useful posts on this forum in the past.)

If the junction box is big enough, like a PVC 6x6x4 deep box it’s fine to install them both together. Good luck with your project

 

[ian-san-diego]

If the junction box is big enough, like a PVC 6x6x4 deep box it’s fine to install them both together. Good luck with your project

This is just what I was looking for. Many thanks!