Hello,
I have an all-in-one washer/dryer unit and it is giving me error codes. I have the manual that describes how to test the various components on the control module, but the introduction to the Component Testing Procedures section has me a little confused. It seems to contradict itself by stating that I need power attached but need to make sure no power is attached. Honestly, I just plan on testing the resistances and for that I know I'm not supposed to have power, but in some of the component specific instructions it seems to want me to have power supplied to the unit. My biggest question has to do with the suggestion that the tests should be performed with a VOM or DVM with a sensitivity of 20,000 ohms-per-volt DC or greater. I have an innova 3320 multimeter and would like to know if I need to purchase something with higher sensitivity?
I've attached a screenshot of the introduction as well as screenshots of the testing instructions, such as they are, for the two components that are giving me error codes. One component is the Wash NTC and the other is the Water Pump(listed just as pump in the chart pictured).
Thanks!
I have an all-in-one washer/dryer unit and it is giving me error codes. I have the manual that describes how to test the various components on the control module, but the introduction to the Component Testing Procedures section has me a little confused. It seems to contradict itself by stating that I need power attached but need to make sure no power is attached. Honestly, I just plan on testing the resistances and for that I know I'm not supposed to have power, but in some of the component specific instructions it seems to want me to have power supplied to the unit. My biggest question has to do with the suggestion that the tests should be performed with a VOM or DVM with a sensitivity of 20,000 ohms-per-volt DC or greater. I have an innova 3320 multimeter and would like to know if I need to purchase something with higher sensitivity?
I've attached a screenshot of the introduction as well as screenshots of the testing instructions, such as they are, for the two components that are giving me error codes. One component is the Wash NTC and the other is the Water Pump(listed just as pump in the chart pictured).
Thanks!