Questions and electrical advice in the Electric Vehicles Advice Forum - Electric Vehicles Advice Forum for the USA, UK, and more. Find advice on electric vehicles and their faults and diagnosis with regards to batteries and reverse charging. Charging stations, charging installation schemes, and various other electrical car issues and fixes. Tesla electric vehicles. BMW Electric Vehicles. Videos, advice answers and questions on all makes and models. 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021..

Some popular forums: Electrical Forum - Electrical Wiring, Theories and Regulations - Periodic Inspection Reporting & Certification - Electrical Jobs

A B C D E F G H I J K L M N O P Q R S T U V W X Y Z #

- Votes
0 Votes
Just taken deilvery of an Electric Car (Mini Electric) and so doing some research into installing a charge point. Supply is a standard Single...
Replies
10
Views
360
0 Votes
Hi all. Desperately trying to find a forum where I can get some help with an electric quad issue. Hoping this is the place. I have issues with...
Replies
3
Views
2K
0 Votes
Hi all Just about to carry out my first EV charger install at the end of the month and im filling out the DNO notification form Im just stuck on...
Replies
11
Views
1K
0 Votes
My Dad is picking up a Nissan Leaf. He is planning to charge it using the granny charger as we have a socket in the porch. Can anyone recommend a...
Replies
12
Views
2K
0 Votes
I am to install a car charger that states a type A RVD is to be installed. Can this be put in the garage from the non rcd side of the board or is...
Replies
10
Views
729
0 Votes
I have been tasked with inspection of testing of our 2 vehicle charging points. other than the standard ZS and rcd times , does anyone know what...
Replies
3
Views
638
0 Votes
Can anyone recommend an EV charger brand/type with load curtailment (throttling) which is easy to interface by manufacturers design, with a remote...
Replies
7
Views
3K
0 Votes
Hello everyone I’m new to the forum and I am trying to wire up a new 12s 7 pin plug that’s on my Ifor Williams trailer Tipping trailer. The...
Replies
2
Views
451
0 Votes
im a final year engineering student and my project is safety monitoring and control within a Formula E/electric car and as part of my dissertation...
Replies
1
Views
420
0 Votes
Has anyone experienced any issues with getting a good enough signal for the customer to be able to use the smart features on a Rolec Wallpod...
Replies
0
Views
791
0 Votes
Hi to all, I would like to get into EV charging equipment installation sector. I would like to obtain example of OZEV grand paperwork and...
Replies
0
Views
625
0 Votes
hi all, currently working on my first quote for an ev charge point. just trying to work out labour costs, I know it varies on different installs...
Replies
0
Views
823
0 Votes
hi all, Hope everyone are well and keeping busy. I am quoting for an ev charging point installation, the only way I can supply it, is to split the...
Replies
2
Views
852
0 Votes
Hi all, with regards to the EVHS grant amount, does the grant include any additional work required, for example if the bonding arrangements were...
Replies
5
Views
1K
0 Votes
Despite several phone calls I cannot get a starigh answer to this, if I buy my tested from say Rolec will it test all other EV cp,s bearing in...
Replies
6
Views
4K
0 Votes
I’m currently looking to get an EV Charger installed at home if anyone is able to or could recommend someone that would be great.
Replies
2
Views
737
0 Votes
Anyone used one of these for kVA calculations? I'm fed up of approximate MD figures. If not what are people using? Heard some have GPS...
Replies
1
Views
492
0 Votes
Hi, With a "granny" charge point, you can just have an extension socket going from your indoor house plug mains and charge your vehicle like that...
Replies
30
Views
5K
0 Votes
Eh up :) A client (also a friend of mine) bought a new electric car, and it came with "free charger install" by Podpoint. As it's not a simple...
Replies
8
Views
3K
0 Votes
Looking for some candid advice. Covid has left my industry in tatters, I'm an Airline pilot. I still have a job, just, but for how much longer...
Replies
5
Views
1K
0 Votes
I use external weatherproof socket (IP66 20A 2gang ) for charging EV car, but noticed plug/socket gets hot. The charger is rated 10Amps. I...
Replies
8
Views
2K
0 Votes
I was just looking at EV courses last night and came across the NICEIC one that would be held in various venues, one being fairly close to me. I...
Replies
21
Views
2K
0 Votes
I have done the c&g courses, done the manufacturers courses, registered with olev all set up to go Got my first EV job come in, nice easy job...
Replies
21
Views
2K
0 Votes
Hello, Yet to dip my toe in EV and have been trying to avoid it to be honest. But have just been presented with a situation and just wanted to...
Replies
1
Views
1K
0 Votes
Hi, I've been asked by the DNO to install a load limiter for the charger as it is right on the MD. I know Podpoint have the CT clamp and cable but...
Replies
3
Views
2K
0 Votes
Howdy- I am a newby to your forum but in hope someone can set me straight on this nagging question in my mind. I am converting my boat's 12 volt...
Replies
13
Views
1K
0 Votes
Hi All, looking for some setup advise around a new EV charger installation at a Domestic Property. The customer has a single phase 100a supply...
Replies
1
Views
945
0 Votes
I am considering fitting a car charger using 6mm SWA to a new isolator switch in the meter cupboard and then 6mm T&E to the CU. It would save...
Replies
3
Views
4K
0 Votes
I run some computer case fans from a 12volt car battery in my Garage to keep the air flow moving and prevent condensation in winter. I borrowed...
Replies
8
Views
548
0 Votes
Hello, My name is Guillermo and I work for Ecoluz Consultores, a Spanish engineering company specialised in the segment of energy efficiency...
Replies
1
Views
495
0 Votes
At some point I'm going to get asked to fit one of the above and I'd like to know a bit more about it from some people that have already fitted...
Replies
28
Views
7K
0 Votes
Hi Guy's, Greetings from Spain! hope everyone is doing well? Name is Dennis 33 years old and have a small small background in electrical...
Replies
1
Views
855
0 Votes
I apologise in advance if this has been covered but I’d like to get confirmation please. I want to register our company with OLEV, I’ve read the...
Replies
3
Views
1K
0 Votes
hiya chaps I did a City and Guilds course, practical assessment and exam for the CG2919 on Monday and Tuesday, we were told about the...
Replies
52
Views
7K
0 Votes
So my understanding is I need to be trained with a particular manufacturer before becoming OLEV registered? Just wondering if anyone has...
Replies
1
Views
1K
0 Votes
hi guys I’m thinking of taking the c&g 2919 course Has anyone taken this course and found they get much work through being OLEV registered. I...
Replies
13
Views
9K
0 Votes
We're getting conflicting views on whether we need specific charger test equipment for EV charger installations in homes and it's very...
Replies
7
Views
851
0 Votes
I am a bit unsure of what Amendment 1 is saying regarding EV charging points and PME. I understand the existing 3 methods in section 722.411.4.1...
Replies
0
Views
647
0 Votes
Was doing a periodic last week and came across one of these outside a factory. The factory has a TN-C-S earthing system and is connected direct to...
Replies
4
Views
1K
0 Votes
I'm just interested in the technicalities of charging points, specifically with PME supplies, I know there's been a few threads on here, but I...
Replies
34
Views
4K
Post a New Thread / Question

New Posts (Please Reply)

This website was designed, optimised and is hosted by Untold Media. Operating under the name Untold Media since 2001.
Top