B
Bakerboy
Hello all.
This is my first post and im looking for a little advice.
Before i explain i would just like to mention that i havent been to see the job yet but this was relayed to me by the builder so information may be abit sparse and slightly incorrect.
Basically there is 3 flats that are all fed from the origin and fused(63amp) and metered outside the basement flat(external wall). There is then 3 sets of tails going through into the basement flat feeding the basement flats C.U, a double pole isolator (45amp) for flat 2 and a D.P isolator(45 amp) for flat 3. From each isolator the feeds to the corresponding flats C.U's are fed in 10mm t&e.
1st question. Is it against any reg that there is isolators for flats 2 and 3 inside flat 1.
2nd question. Whats the best way for upgrade all cabling and to have each flats supply independant of the other.
Thanks
This is my first post and im looking for a little advice.
Before i explain i would just like to mention that i havent been to see the job yet but this was relayed to me by the builder so information may be abit sparse and slightly incorrect.
Basically there is 3 flats that are all fed from the origin and fused(63amp) and metered outside the basement flat(external wall). There is then 3 sets of tails going through into the basement flat feeding the basement flats C.U, a double pole isolator (45amp) for flat 2 and a D.P isolator(45 amp) for flat 3. From each isolator the feeds to the corresponding flats C.U's are fed in 10mm t&e.
1st question. Is it against any reg that there is isolators for flats 2 and 3 inside flat 1.
2nd question. Whats the best way for upgrade all cabling and to have each flats supply independant of the other.
Thanks
