• IMPORTANT: Please note that nobody on this forum should be seeking from or providing advice to those who are not competent and / or trained and qualified in their field (local laws permitting). There is a discussion thread on this global industry-wide matter HERE. This also has more information about the warning with regards to sharing electrical advice in some countries. By using this forum you do so in agreement to this.
Questions and electrical advice in the Electrical Talk - All Other Countries - A forum for all discussion related to overseas electrical works. Find answers to questions related to electrics outside of the UK. Different laws will apply for different countries and we're primarily a UK electrical forum and our advice usually applies to only UK electrics. So chat in this one if your problem isn't about something electrical in the UK..

Some popular forums: Electrical Forum - Electrical Wiring, Theories and Regulations - Periodic Inspection Reporting & Certification - Electrical Jobs

A B C D E F G H I J K L M N O P Q R S T U V W X Y Z #
  • Sticky
So this has been posted in the following forum categories:- American Electrical Forum -...
Replies
2
Views
3K
M
Replies
Views
N/A
  • Sticky
For you guys thinking of going abroad to work you will more than likely find that your life insurance will not cover you to work overseas. I...
Replies
1
Views
4K
Hey guys On the summary test data, the "Minimum IR" Is that a global reading they're looking for ie ; just the entire installation tested Or is...
Replies
34
Views
1K
  • Question
I bougt multimeter and i wanted to test it at home i meausred volts in the outlet and it said 225V.Then when i didnt need it anymore i put it away...
Replies
17
Views
894
Hi everybody. A newbie here. So, please point to me if I am in the wrong room. I am really considering applying for registration with the EWRB in...
Replies
0
Views
1K
I am looking for electrician I can work with or engineer . I live in African country Can someone help
Replies
11
Views
3K
If I turn off the breaker and measure the voltage across the breaker (upper and lower screws), the voltage is around 180 volt. If I measure the...
Replies
3
Views
551
Sorry, my first time posting a question here. So before you berate me... Yes I do have qualifications.......but my area of work is very specific...
Replies
6
Views
774
Hello guys, can somebody help with the name of this plug for this socket that is showed in the pictures attached. Thank you!
Replies
7
Views
3K
Hello, just let`s find out if there is a strong community of Polish electricians or trainees here. Cheers, Przemek
Replies
18
Views
1K
Hi guys I’m looking at moving to New Zealand as soon as Covid allows and just have a few questions regarding required qualifications to work in...
Replies
0
Views
842
Can anyway identify the board and MCBs from the pictures? This installation is in a house in Tanzania - the actual installation has a much bigger...
Replies
20
Views
4K
Hi - No idea if I am writing in the right place. Please, I cannot get a straight answer when the temperature is 0- -20 Celsius - where can I find...
Replies
5
Views
1K
I have been meeting with solar system installers to install a grid-tied system at my house. Before I commit I want to verify whether I need to...
Replies
14
Views
1K
J
can anyone help with finding out the requirmnts for working in holland i do mainly commercial/ industrial installations and im looking for a start...
Replies
2
Views
5K
J
Hi all. I'm due to undertake the re-wire of a two bed property in France. I have no previous experience of French wiring. I would very much...
Replies
15
Views
21K
I am trying to connect a smart light switch but there is not neutral. Next to the switch there is a socket with a neutral but it is under a...
Replies
6
Views
1K
Putting in a new garage sub panel, but none of the wires pulled to the garage were marked. There are three #8 wires, 2 hot and a neutral. The...
Replies
7
Views
931
I have a problem with lighting protection in a charity in Zambia. The earthing is TT, i.e. earth pits or rods are provided for almost every...
Replies
10
Views
1K
I have a question about adding a second receptacle on a 30A 240 circuit. I have a 10-30 receptacle in my laundry room. Unused since I have a gas...
Replies
3
Views
519
I just tried to replace the light switch but I didn't took a picture or even try to look how it was wired. I'm getting out of my mind I've tried...
Replies
11
Views
816
Would like your opinions on the following setup. 300A 3 phase TT incoming supply feeding 15 units with 50A TNS obviously some link somewhere...
Replies
12
Views
1K
All fluorescent lights in this house (230V) are connected "1 switch - 1 light". So I have no where to get inspiration how to connect second...
Replies
7
Views
766
Hi Guys, in an installation with one main Distribution board and several submain-DBs, do when you measure Zdb on a submain-DB incomer? and do we...
Replies
6
Views
2K
Replies
Views
N/A
Hi I'm new to this forum.I am currently an electrician apprentice in Hong Kong. I yearn to work overseas. However, licenses may be required in...
Replies
4
Views
2K
Hi, I received a 9kW 3ph heater from a friend from india, i was hoping to use this in steam production for a distillation project i am working at...
Replies
22
Views
3K
Why is Delta star transformer used for step down transformer and star delta for step up transformer? According to this book, Electrical Power...
Replies
3
Views
1K
Hi My name is Allen Brauteseth from Cape Town South Africa. I am a Qualified electrician and am sitting with a problem being I have a commercial...
Replies
9
Views
2K
I have in LED light which has stopped working. It's well-travelled, made in China, bought in Azerbaijan and installed in the UK. I assume the...
Replies
5
Views
723
How would everyone feel about a 240Y system in a building with everything connected Line-Line? I personally like (want) this system. No TN-C...
Replies
18
Views
986
Hi, I want to build for my son that loves football a panel to hang on our garden wall. Whenever he hits the panel with his ball, a light should...
Replies
14
Views
1K
Hello Everyone, I am from India. Things were good [seemed to be good] with temporary electric connection [single phase, 230v] to our new house...
Replies
3
Views
8K
I purchased an Ecosmart 8 Instantaneous hot water system from Amazon and its really made for the North American market. The wiring says it need...
Replies
2
Views
574
Hi everyone, I rented out an outdoor space for a party and they brought a DJ. Unfortunately there was a water pipe that burst and showered the...
Replies
17
Views
939
I'm sorry if my question is a bit basic but this part is not in my field. Can somebody tell me how do I do to wire a 9/24 triple switch circuit...
Replies
1
Views
415
Bobster
B
I tried to put in a smart switch, which should be simple enough but when I took the plate off I was surprised at what I saw. There are two...
Replies
8
Views
596
Hi guys, Starting to get some itchy feet here in the UK and thinking that maybe it's time to move abroad with the family. Not entirely set on...
Replies
1
Views
863
Post a New Thread / Question

New Posts (Please Reply)

Top