Questions and electrical advice in the Periodic Inspection Reporting & Certification - This Section is STRICTLY for testing PROBLEMS which members have occured, misunderstood readings, Periodic Inspection Reporting / Electrical Installation Condition Reports, Mathematical Equations/Solutions, Part P and other legislation which require you to Inspect and Test..

Some popular forums: Electrical Forum - Electrical Wiring, Theories and Regulations - Periodic Inspection Reporting & Certification - Electrician Jobs

Search for tools and product advice,
New to this forum Hello All :) Following were listed in my EICR report. Any help to identify are these really C2 or possible C3? Thanks for your time.
Replies
3
Views
1K
3ph 60 3036 fuses, looking for BS No for the EICR?
Replies
2
Views
3K
C3..service head requires improvement or not??
Replies
14
Views
2K
Hi. I found a radial power circuit on an EICR yesterday wired in 6mm2 flat twin PVC cable and have some concerns. I know that the MCB is designed...
Replies
7
Views
5K
Hi, if I have a DB that has a main switch and then a seperate 63A RCD that protects number of single circuits . how do i include that RCD in the...
Replies
3
Views
2K
Hi guys I've been asked to do a EICR for a landlord on his 6 bed house. My queries are 1. Do I have to be a member of a scheme to do this...
Replies
24
Views
4K
Evening..I'm after a bit of advice coding an EICR I have done today, I don't do an abundance of them so just a bit unsure. 1. 3 sockets spurring...
Replies
17
Views
3K
Hi testing a theatre. Took over job 4 years ago as test certs had run out. Did a full test every circuit in first year and now test 1/3 of all db...
Replies
1
Views
707
Hi Quick question as I can’t seem to find the regulation in the BBB. Carried out an EICR and found the load for the water tank was wired in 2.5 t...
Replies
12
Views
3K
Hi all I am about 2 years retired after being NICEIC registered for over 20 years. An old customer just a little concerned about an EICR just been...
Replies
16
Views
2K
Hi, My friend has just had EICR test done on 3 bedroom house. 5 year old house. The house failed on - bathroom light under 2.25m inside...
Replies
49
Views
4K
When doing an EICR what code (if any) would you guys give to a piece of twin and earth cable in a duct outside. The duct runs from the side of...
Replies
18
Views
3K
Hi guys I was called to a clients house today, because for a week they've had no hot water which is supplied by their immersion heater in the...
Replies
16
Views
16K
an eicr was carried out to an industrial plant area were the zs readings were all high readings above the maximum for a tns installation i...
Replies
9
Views
2K
I've done a few EICRs for a landlord and the latest one of his I've given an unsatisfactory, I've advised changing the CU - existing one is old...
Replies
18
Views
2K
We’ve had two control panels given a C2 for being too rusty. Both of their switches work properly and they are not hanging!! Both would pass the...
Replies
6
Views
1K
I have just carried out an EICR. Earthing is TT. A 4mm green/yellow conductor leaves the CU and disappears under the conservatory, I get 158Ω...
Replies
20
Views
6K
Hi sorry a basic question. I have no regs books and I’m still learning. on a eicr would a board with no mcb e.g rewirable fuses be unsatisfactory...
Replies
3
Views
1K
Had a EICR completed on a commercial property and it has come back with N/A in the Ze box and also N/A in all the boxes regarding the serial...
Replies
11
Views
2K
Just wondered what opinion people have of bonding of short lengths of copper water pipes, this is in the communal area of flats . above the copper...
Replies
36
Views
12K
Landlord has had an EICR done on the property as is required under the new PRS legislation, got a copy of the report and I'm not overly impressed...
Replies
15
Views
3K
i hold my 2377 so i understand how your ment to test ie remove plug cover to check connections and fuse size so can someone please tell me how 4...
Replies
15
Views
4K
Hi Everyone Just a question bothering me as you cannot do Insulation resistance test on smoke detectors as they can become damaged so obviously...
Replies
5
Views
4K
what the showed on the megger tester vol o-l, doing a EICR on a flat and doing continuity testing every thing isolated and then head in a spin...
Replies
2
Views
2K
Good Morning ALL I have a terraced house and let out . Novice Landlard and come across to this site/ forum Many Thanks and informative, have had...
Replies
36
Views
4K
Hello, I have been asked to do a eicr on a property that I have found to have no CPC in the lighting circuit. Just wanted to know if this...
Replies
25
Views
16K
M
Hi, I have recently carried out a periodic test and inspection on 1960s purpose built flat. The means of earthing was via the main gas pipe...
Replies
36
Views
15K
Evening all If you were to carry out an eicr and you came across a TT system what is the procedure and required tests....I can see how you would...
Replies
5
Views
3K
What would you put-in the EIC column for Max Loop reading permitted for a TT system, for a 32 amp 60898. Protected by Rcd 30ma,Dual split DB.
Replies
32
Views
4K
Ground floor flat, 3 hallway down lighters not fire rated no fire hoods take out a down light and I can look up and see the flat above...
Replies
9
Views
942
Hi Guys, Recent EICR carried out at a Church & Hall. Would you code no SPD present at Supply origin & should the Lightning Protection System be...
Replies
11
Views
7K
Hi All, Ive been asked to carry out an EICR on a kiosk in a shopping centre. They have a temporary board under the till. Ive tried to research...
Replies
6
Views
968
I had an EICR done in 2014. Some loose trunking on a wire to the showers self isolator based on the wall was graded C3. In an EICR done this week...
Replies
68
Views
5K
This has me as amused as perplexed.... took a look at a place the other day just as a cursory visit in advance to quoting for a proper inspection...
Replies
8
Views
1K
I am an electrician nearing retirement, so really I should know this but am not sure. I have not done any installation or real heavy electrical...
Replies
8
Views
4K
Hi, I need to get an EICR report done on my dad's rental flat. However, there is a possible complication due to the fact it does not have it's...
Replies
8
Views
1K
A
hi just bought a second hand kt63 mft the unit is in like new never been used. but it does not have a serial number on it anywhere apart from one...
Replies
8
Views
6K
As above really. First time I have seen this but its basically 16mm twin and earth connected straight into the outgoing side of the meter, and...
Replies
17
Views
3K
carrying out an eicr on a building recently we found the external ze reading to be extremely low ie 0.02ohms. so by measurement and testing are...
Replies
19
Views
4K
Anyone have any ideas on this one! Just pricing a job and it's coming out but... Code breakers doesn't cover this!
Replies
8
Views
1K
During an EICR I have come across a Solis -1P4K-4G inverter I believe this has no transformer , it is currently on a type AC RCD. It’s difficult...
Replies
1
Views
3K
Hi, just undertaking an EICR on a factory and have came across, some perished shrouds inside of an old main frame board, i can not seem to find a...
Replies
1
Views
1K
The picture is a section of text from the October edition of Professionals Electrician, NAPIT Codebreakers. I have an issue with coding...
Replies
33
Views
5K
Yes, still doubting my own judgement when it comes to supp bonding and EICRs, so would welcome any thoughts on the latest one. Newish flat...
Replies
6
Views
1K
I was recently watching John Ward's video series on Electrical Installation Testing. In the part where he discusses measuring Ze, he states that...
Replies
21
Views
5K
Good morning, to carry out IR testing for armoured power cables in man panels ( pls see below image), do you remove the cable from circuit...
Replies
3
Views
2K
Hi All Am continuously getting failed EICR'S sent over to quote on remedials for non fire rated downlights. These are lights in question. I see...
Replies
17
Views
5K
Good morning everyone, Is testing bus bars part of fixed wiring test? if yes, how do we test them? for example, shall we check the connections on...
Replies
0
Views
1K
Hi all, Recently did an Eicr. I failed it due to shower being fitted on the opp side to the taps. I was lead to belive it was a C2...
Replies
26
Views
3K
When we consider EICR reports for the Private Rented Sector, we usually think an electrician completing any EICR should be qualified and...
Replies
12
Views
18K
Post a New Thread / Question

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock